Teledyne Stud Sensor 452 Manual de usuario descargar pdf (Pagina 18)

Teledyne API M452 Ozone Sensor Instruction Manual, 02852, Rev. E

4-1

4 Installation

4.1 Unpacking

Upon receiving the M452 please verify that no apparent shipping damage

has occurred. If damage has occurred please advise shipper first, then

Teledyne API.

4.2 Mechanical Installation

Mount the M452 to a stable platform using four #8-32UNC screws. See

Figure 2-1 for mounting hole dimensions.

NOTE

If the mounting platform is non-conductive or

note connected to earth ground, then a separate

connection to earth ground should be made using

one of the mounting screws. Failure to provide a

proper earth ground connection may make the

M452 susceptible to electrical interference from

external sources.

4.3 Electrical Connections

Electrical connections are made to the M452 using the 15 pin D-Sub

connector on the top of the device. Figure 4-1 shows the pin-out of the 15-

pin connector and typical connections.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Sin comentarios

Teledyne Stud Sensor 452 Manual de usuario Pagina 18