Teledyne O3 Manual de usuario descargar pdf (Pagina 35)

Teledyne API Model 401 O

Photometric Calibrator Instruction Manual, 01124, Rev. J2

Table 2-2: System Modes

Mode Meaning

STBY xxxx (1) Standby mode (Photometer is operating normally)

ZERO CAL x (2) Zero check in progress

GN CAL x (2) Span check in progress

ASEQ xxx (5) x (2) Multi-point calibration in progress

HOLD OFF Hold off delay after power reset

D/A OUTPUT (3) Test analog output channels

BCAL ZERO Bench zero calibration

BCAL SPAN Bench span calibration

SETUP xxx (4) Configuring analyzer (operation continues)

(1) xxxx = AZS ( Auto Zero & Span programmed), AZ2S (Auto Zero & 2 span points; 25% &

100% of O

set concentration) programmed AZ5S

(Zero & 5 span points; 20%, 40%, 60%, 80% & 100% of O

set concentration) programmed.

(2) x = M (manual), A (auto), R (remote)

(3) diagnostic test modes

(4) xxx = software revision

(5) 0%, 20%, 25%, 40%, 60%, 80%, 100%

The message field shows test measurements or warning messages. Table 2-3 and Table 2-4

summarize the test measurements and warning messages and their meanings. Refer to Sections 4

and 5 for detailed information on viewing test measurements and warning messages and clearing

warnings.

2-5

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 113 114

Sin comentarios

Teledyne O3 Manual de usuario Pagina 35